







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Why Doral Homeowners Choose Abodu Construction
We build and repair Abodu backyard homes, ADUs, and garage conversions in Doral as an independent local contractor, not as an authorized Abodu dealer. Our work on Abodu units focuses on what the manufacturer’s drawings don’t cover: site prep on Doral’s fill soil, Florida-specific tie-downs, and flashing rebuilt for wind-driven rain. If you own an Abodu One, Two, Studio, or a garage conversion package in Doral, we can assess the panels, the footing, and the envelope in one visit.
Doral is a logistics boomtown built on fill over the Everglades. Thousands of warehouses and tilt-wall industrial shells went up in two decades on former wetlands, and the residential side followed on raised pads over drained marsh. That ground behaves differently than the coral rock and upland soils most prefab manufacturers design for. When an Abodu unit lands on it, the panels are fine. The site is what needs attention.
We’re not affiliated with or authorized by Abodu. We’re an independent Abodu service provider. Call (833) 734-5128 for a free estimate on your Doral Abodu project.
Why Trust Barrett & Sons Construction Doral for Your Abodu Construction?

Our technicians have up to 28 years of experience, and a good share of that is modular and prefab panel work in Miami-Dade, not traditional stick-framing. Abodu’s system is panelized: factory-built wall, floor, and roof components assembled on site with specified connectors, sealants, and flashing kits. That means small choices matter. The wrong sealant on a panel seam fails in one wet season. The correct one, installed to spec, holds.
We use Abodu-specified OEM connectors, flashing kits, and panel sealants whenever they’re available, because the structural warranty depends on them. For finishes like flooring, trim, and fixtures, we’ll often recommend quality aftermarket equivalents that handle South Florida humidity better than the factory defaults. That’s a judgment call we make with you, in writing, before anything is ordered.
Every eligible job gets permits pulled and inspections signed. Every price change arrives as a written change order before work proceeds. And every completed job is backed by the written 90-Day Done Right Promise. That’s the standard we’ve held since 1998.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Common Abodu Construction Problems We Fix in Doral
Most of what we see on Abodu units in Doral traces back to the ground the unit sits on or the climate it sits in, not to the panels themselves.
- Panel seam separation at wall-to-floor joints. Common on Doral’s fill-heavy lots where Abodu units sit on shallow footings. The soil settles at a different rate than the unit’s frame, and the seam opens just enough to let moisture in. Left alone, it becomes a soft spot in the floor and a stain on the wall board.
- Moisture intrusion at window and door penetrations. The factory flashing is designed for a drier climate than South Florida’s wind-driven rain. During a wet-season storm, water gets pushed sideways into the rough opening. We rebuild those transitions with Florida-rated flashing and backer rod.
- Roof-to-wall transition leaks on flat or low-slope Abodu roof panels. Sealant degrades faster under UV and hurricane-season thermal cycling. The seam that held in year one may be the first leak in year three.
- Sticking or misaligned sliding doors and windows. The modular frame shifts on expansive Doral soils. Doors that slid fine last spring drag by August. Usually the frame and the footing need attention, not the door hardware.
- Ponding near the pad. On fill lots with high water tables, Abodu units sometimes sit in a low spot that collects stormwater. Drainage correction, not panel replacement, is usually the answer.
A typical Abodu call starts with a homeowner noticing a soft spot or water stain near the floor line of a backyard unit after heavy summer rain. The usual cause is failed sealant and flashing at a panel seam where the unit settles on Doral’s sandy fill, letting water wick into the wall cavity. A qualified local pro would re-level or shim the footing, replace the flashing and sealant per the panel system’s spec, and verify the roof-to-wall transition before touching interior finishes.
Abodu Parts & Our Repair-vs-Replace Approach

For a prefab panel home, the structural warranty is tied to specific parts. We use Abodu-specified connectors, flashing kits, and panel sealants wherever they’re available. When they’re not, we tell you and we wait for them rather than substituting a generic part that voids your coverage. For finishes, flooring, trim, and fixtures, quality aftermarket equivalents are usually fine and often more suited to Doral’s humidity.
We don’t claim to stock Abodu parts locally. Each job gets its parts sourced to the specific model and panel configuration, and lead times are quoted upfront.
On repair versus replace: repair the shell and the envelope first. Most Abodu issues we see in Doral are site-prep and flashing problems, not panel failure. A wall that’s separated at a seam is a footing and flashing repair, not a wall replacement. A roof transition leak is a sealant and flashing job, not a new roof. We’ll tell you straight if a panel is genuinely compromised, and we’ll show you why before we recommend replacement.
Call (833) 734-5128 for a free second opinion on any written estimate for Abodu work.
Our Abodu Service Process – Step by Step
- 1
Diagnosis. We walk the unit, the footing, and the drainage. We note panel joint condition, flashing integrity at every opening, roof transition, and any signs of frame movement. If soil settlement is suspected, we say so.
- 2
Written scope and change orders. Everything we’ll do and every allowance we’re assuming arrives in writing before work starts. If the scope changes once the wall is open, you get a written change order first.
- 3
Repair or install. Panel connectors, flashing kits, and sealants installed per the Abodu panel system spec, with Florida-specific detailing where the factory detailing isn’t enough for our storm season.
- 4
Water test and inspection. We verify the roof-to-wall transition and every opening under a hose test, and we call the Miami-Dade inspector where the scope requires it.
- 5
Warranty and 90-Day Done Right Promise. Every completed job carries the written 90-Day Done Right Promise. If something’s wrong, one call brings us back.
See the difference
Before
After
Before
After
Before
AfterAbodu Products We Service & Install in Doral
We work on the full Abodu residential line as it shows up in Doral: the Abodu One, the 650 sq ft one-bedroom ADU that’s the most common unit we’re called to; the two-bedroom Abodu Two; the open-plan Abodu Studio; and the Abodu Garage Conversion package. Work ranges from site prep, footing, and drainage correction to panel seam repair, window and door flashing, roof transition work, and full ADU construction for a new unit on your lot. If your model isn’t listed, ask.
We Also Service These Brands
We work across the trades, so an Abodu job rarely stops at the panels. Our crews handle KraftMaid cabinetry and Kohler fixtures when the interior finish is part of the scope, GAF roofing systems on adjacent home structures, and PGT impact windows and doors when the main house needs matching upgrades. You’re not calling a single-brand specialist who hands you off for everything else.
FAQs – Abodu Construction Service in Doral

No. We’re an independent Abodu service provider. We’re not an Abodu dealer, we’re not authorized by Abodu, and we don’t claim any manufacturer endorsement. What we bring is experience assembling, finishing, and repairing modular and prefab panel structures in Miami-Dade’s climate and soils.
Yes, wherever they’re available. Abodu-specified connectors, flashing kits, and panel sealants are what we use for anything structural or envelope-related. For finishes, flooring, trim, and fixtures, we may recommend quality aftermarket equivalents that hold up better in South Florida humidity. We tell you which is which, in writing, before ordering.
A panel seam repair or flashing rebuild is usually one to two days of on-site work. A full ADU construction on your Doral lot is a multi-month project once permits, site prep, and utility trenching are factored in. Roof repairs are typically a single visit. Call (833) 734-5128 for an estimate on your specific scope.
We service and install the Abodu One, Abodu Two, Abodu Studio, and the Abodu Garage Conversion package. That covers the units we see on Doral lots. If you have a different Abodu model or configuration, call and describe it. We’ll tell you yes or no straight.
Not if the work is done to spec. Using Abodu-specified connectors, flashing kits, and sealants is the way to keep the structural warranty intact. Where a repair touches a warrantied component, we follow the panel system’s detailing and we document what we did. We’ll flag anything that could affect coverage before we touch it.
Site work, panel repair, and finish work vary with the scope, so the numbers below are the ranges we quote in Doral. Every job gets a written line-item estimate first.
| Project | Typical Range |
|---|---|
| ADU Construction | $90,000 – $220,000 |
| Home Addition | $45,000 – $130,000 |
| Garage Conversion | $30,000 – $80,000 |
| Roof Repair | $400 – $1,800 |
| Roof Replacement | $8,000 – $20,000 |
Call (833) 734-5128 for an exact quote. Estimates are free, and the second opinion on any written estimate you already have is free too.
Book Your Abodu Service in Doral, FL
If your Abodu unit has a seam, a leak, or a soft spot, or you’re planning a new ADU or garage conversion on a Doral lot, call us. We’ll walk the site, quote it in writing, and pull the permits. Call (833) 734-5128 for a free estimate. A live person answers, day or night.
Written by the team at Barrett & Sons Construction Doral.












